Chia sẻSơ đồ mạch (Schematic) Xiaomi Mi Pad 1

#XiaomiMiPad1
Đây là sơ đồ mạch (Schematic) của máy Xiaomi Mi Pad 1 , sơ đồ này sẽ hỗ trợ đắc lực cho anh em nào cần sửa chữa phần cứng model này

​

Download: <Bạn vui lòng đăng nhập hoặc đăng ký để xem được nội dung này!>

 

 

Xiaomi Mi_Pad 1

<Bạn vui lòng đăng nhập hoặc đăng ký để xem được nội dung này!>

 

 

[QUOTE = "SPEC, post: 78731, member: 24487"] # XiaomiMiPad1
This is a schematic diagram of the Xiaomi Mi Pad 1, which will greatly assist the brother who needs to repair this model hardware.

​

Download: <Bạn vui lòng đăng nhập hoặc đăng ký để xem được nội dung này!>

  [/ QUOTE]
can u please show me mi pad 1 edl tét point

 

You want to unbrick your mi pad ?
Please follow this instruction:
..................................................
On the PC , run Miflash ( follow other guides on forum how to use it and flash )
Remove the plastic cover : with the fingernail you should easily separate the plastic cover from the screen , running around the perimeter; the cover is quite soft , so don’t worry to break it. In the area of the camera cover there’s some scotch tape.
Remove the plastic panel near the battery: there are a lot of screws, by unscrewing them you LOSE THE WARRANTY!



Disconnect the battery flat cable by pulling it gently up , it’s very easy to do
Connect an usb cable to the mipad side but don’t connect it to the PC, wait
Make a bridge ( short circuit ) between the two pads located inside the SD card slot: you can use everything that is metallic .
Connect the other side of usb cable to the PC , keeping the short circuit.
Once you connect it , remove the short circuit and Miflash should recognize the device ( the pc detects a a new device USB (Nvidia, Qualcomm) Boot-recovery driver for Mobile devices )
The first time I did this, miflash saw nothing ( but the driver were detect ) so I disconnect the usb cable gain , made the bridge ( short circuit again ) , connect the usb cable again and miflash then saw the device.
Then you have just to flash it with miflash.
After flashing , connect the battery , close everything and run your mipad.